The adjustable height table is designed to improve the worker’s ergonomics. The worktop with adjustable height can be adjusted to suit people of different heights, making it possible to obtain a working posture that is ergonomically the most suitable for each individual.
Trolleys with adjustable height can be found in the product range of our subsidiary Kailin Oy. Further information: www.kailin.fi/adjustable trolleys
The table is always custom-made to a length that meets the customer’s requirements. The height adjustment is carried out using a lift mechanism with a 200 mm adjustment range. The frame of the table can be fitted with shelves or drawers, or the space can be left empty to accommodate trolleys.
Korkeudensäätöpöytä, takareunan korotus, ritilähyllyä 1 tasossa
The adjustment range of adjustable height tables is 700–900 mm for obtaining an ergonomic working height. The table can also be made lower. The table dimensions can be freely chosen. The table cover can be provided with a raised rear edge where necessary.
The tables are custom made to order, so it is advisable to check the dimensions (length x width x height) when placing the order. It is also worthwhile to mention if the table is intended for heavy duty use.
CLEANING
Stainless steel equipment and fixtures must be cleaned on a regular basis to prevent them from rusting. A water wash is often sufficient for cleaning a stainless steel surface; hot water and steam can be used in special cases.
Impurities and deposits that have adhered to the stainless steel surface can be removed by rubbing them with an emery cloth, for example. NOTE! The emery cloth must be non-ferrous. It is advisable to first try the treatment on a less noticeable part of the product.
Wiping with a damp cloth is normally sufficient for cleaning the electronic components used in the adjustable height table, such as lifters and switch panels. A soft brush, water and a mild detergent solution can be used for cleaning more stubborn stains. The electric components used in the adjustable height table are only splash-proof, so washing with a pressure washer is strictly forbidden.
DETERGENTS
Standard cleaning powders or power detergents such as soda, borax or sodium perborate can be used for cleaning stainless steel surfaces.
Alkaline solutions, such as soda, ammonia and diluted soda lye, can be used for dissolving grease. Acetone, petrol, alcohol and similar organic solvents can also be used for removing grease deposits or other water-insoluble matter.
Detergents that contain sulphuric or hydrochloric acid may not be used for cleaning stainless steel surfaces.
DISINFECTION
The sterilising agents used for disinfection often contain sodium hypochlorite or potassium hypochlorite. However, these substances are dangerous to stainless steel as they easily give rise to pitting corrosion. Other disinfectants that contain chlorine, such as chloramines, are also dangerous. The most affordable disinfectant that is suitable for stainless steel is nitric acid; even mild concentration solutions have a bactericidal effect.
TREATMENT AFTER CLEANING
The detergent must be carefully cleaned from the steel surface. Rinsing with plenty of water is usually sufficient for this purpose. If acidic detergents are used, a pre-rinse should be carried out with a neutralising solution, such as soda.
The user must always ensure that the room concerned is sufficiently ventilated, proper protective gear is used and any in-house occupational heath and safety instructions are complied with.
